Electric ovensBake and Broil Elements
A bake element with a blister, a split or a bright spot that flares and dies has burned through. The technician confirms it with a resistance reading and replaces it, including hidden bake elements tucked under the oven floor.
- Element resistance and ground test
- Hidden bake element access and swap
- Broil element and terminal check
Gas ovensBake and Broil Igniters
A gas oven glow bar can glow orange and still be too weak to open the safety valve. The pro clamps an amp meter on the igniter circuit and compares the draw to the valve spec; a weak igniter is the most common reason a gas oven will not light.
- Igniter amperage draw test
- Gas safety valve check
- Broil igniter diagnosis
TemperatureSensor, Calibration and Hot or Cold Ovens
Recipes failing at the right setting point to the oven sensor or the control. The technician reads the RTD resistance, runs the oven with a thermocouple probe in the center rack, and adjusts the temperature offset if the hardware tests good.
- RTD sensor resistance test
- Thermocouple probe temperature check
- Calibration and offset adjustment
Self-cleanDoor Locks and Thermal Fuses
Self-clean runs the cavity extremely hot, which is when door lock motors, lock switches and thermal fuses fail. A door stuck locked after the cycle, or an oven that went dead mid-clean, both fall here.
- Door lock motor and switch test
- Releasing a door stuck locked
- Thermal fuse and wiring check
ConvectionConvection Fan and Element
A convection oven that grinds, stays silent, or cooks unevenly on the convection setting may have a failed fan motor or a broken element behind the rear panel. The tech removes the back cover and tests both.
- Fan motor winding and bearing check
- Convection element continuity
- Fan blade and rear panel inspection
Controls and doorControl Boards, F-Codes, Hinges and Gaskets
The technician reads the fault code, checks the relay outputs and wiring, and only replaces the board when tests point there. Door hinges and the fiberglass or silicone gasket are inspected too, since a poor seal wastes heat.
- Fault code and relay output testing
- Control or relay board replacement
- Door hinge and gasket replacement